Network Router User Manual
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Configuring Basic Settings
- 3. User Mode Operation
- 4. Admin Mode Operation
- 5. Application and Examples
- 6. Trouble Shooting
- 6.1 Checking If the Hardware Status Is OK or Not
- 6.2 Checking If the Network Connection Settings on Your
- 6.3 Pinging the Router from Your Computer
- 6.4 Checking If the ISP Settings are OK or Not
- 6.5 Forcing Vigor Router into TFTP Mode for Performing the
- 6.6 Backing to Factory Default Setting If Neces
- 6.7 Contacting Your Dealer
Vigor2750 Series User’s Guide
217
When the router connects to the tunnel broker, the router will use RADVD to transmit the
prefix to the PC on LAN. Next, the PC will generate one set of IPv6 public IP (see the figure
below). Users can use such IP for connecting to IPv6 network.
When your PC obtains the IPv6 address, please connect to http://www.ipv6.org
. If your PC
access Internet via IPv6 connection, your IPv6 address will be shown on the web page
immediately. Refer to the following figure.