Network Router User Manual
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Configuring Basic Settings
- 3. User Mode Operation
- 4. Admin Mode Operation
- 5. Application and Examples
- 6. Trouble Shooting
- 6.1 Checking If the Hardware Status Is OK or Not
- 6.2 Checking If the Network Connection Settings on Your
- 6.3 Pinging the Router from Your Computer
- 6.4 Checking If the ISP Settings are OK or Not
- 6.5 Forcing Vigor Router into TFTP Mode for Performing the
- 6.6 Backing to Factory Default Setting If Neces
- 6.7 Contacting Your Dealer
Vigor2750 Series User’s Guide
145
Name Specify the name for the defined network service.
Protocol Specify the transport layer protocol. It could be TCP, UDP and
TCP+UDP.
Start Port Specify the starting port number of the service offered by the
local host.
End Port (optional) Specify the ending port number of the service offered by the
local host.
Local Host Enter the private IP address of the local host.
Local Port (optional) If it is configured, the forwarded traffic is mapped to this port
on the local host.