Network Router User Manual
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Configuring Basic Settings
- 3. User Mode Operation
- 4. Admin Mode Operation
- 5. Application and Examples
- 6. Trouble Shooting
- 6.1 Checking If the Hardware Status Is OK or Not
- 6.2 Checking If the Network Connection Settings on Your
- 6.3 Pinging the Router from Your Computer
- 6.4 Checking If the ISP Settings are OK or Not
- 6.5 Forcing Vigor Router into TFTP Mode for Performing the
- 6.6 Backing to Factory Default Setting If Neces
- 6.7 Contacting Your Dealer
Vigor2750 Series User’s Guide
100
A
A
d
d
d
d
i
i
n
n
g
g
a
a
N
N
e
e
w
w
R
R
u
u
l
l
e
e
Click Add New Rule to configure a new rule for IPv6 Firewall.
Note: You can set up to 20 sets of IPv6 rules.
Name Type a name for the rule.
Protocol Specify a protocol for this rule.
Source IP Type Determine the IP type as the source.
Source IP Type the IP address here if you choose Single as Source
IP Type.
Source Subnet Type the subnet mask here if you choose Subnet as
Source IP Type.
Destination IP Type Determine the IP type as the destination.
Destination IP Type the IP address here if you choose Single as
Destination IP Type.