Operation Manual

Vigor2133 Series User’s Guide
685
This command allows to set parameters related to AP management control.
S
S
y
y
n
n
t
t
a
a
x
x
apm lbcfg [set] [value]
apm lbcfg[show]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
set It means to set the load balance configuration file for APM.
Show It shows the configuration value.
[value] You need to type 10 numbers in this field. Each number represents
different setting value.
[1] – The first number means the load balance function.
1 – enable load balance,
0 – disable load balance.
[2] – The second number means the station limit function.
1 –enable station limit,
0 – disable station limit.
[3] – The third number means the traffic limit function.
1 – enable traffic limit,
0 – disable traffic limit.
[4] – The forth number means the limit num of station.
Available range is 3~64.
[5] – The fifth number means the upload limit function.
1 – enable upload limit,
0 – disable upload limit.
[6] – The sixth number means the download limit function.
1 – enable download limit,
0 – disable download limit.
[7] – The seventh number means disassociation by idle time.
1 – enable disassociation,
0 – disable disassociation.
[8] – The eighth number means to enable or disable disassociation
by signal strength.
1 – enable disassociation,
0 – disable disassociation.
[9] – The ninth number means to determine the unit of traffic
limit (for upload)
1 – Mbps
0 – kbps
[10] – The tenth number means to determine the unit of traffic limit
(for download)
1 – Mbps
0 – kbps
[11]Enter RSSI threshold (-200 ~ -50 dbm)
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> apm lbcfg set 1 1 1 32 100 200 1 1 1 0 -200
> apm lbcfg show
apm LoadBalance Config :
1. Enable LoadBalance : 1