Operation Manual
Vigor2133 Series User’s Guide
678
[method_idx] method_idx - Specify which method will be used.
At present, dot1x_phase1 can only support PEAP now. So only “1”
can be used for it.
set_dot1x_phase2
[method_idx]
Set the phase2 method for 802.1X authentication of RADIUS server.
method_idx - Specify which method will be used.
Dot1x_phase2 can only support MS-CHAPv2 now. So only “1” can be
used for it.
-e Set method for dot1x_phase1 or dot1x_phase2.
-d Delete method for dot1x_phase1 or dot1x_phase2.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> radius client add 1 -i 192.168.1.1 -m 255.255.255.0 -s 123
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
o
o
l
l
This command allows Administrator to set the white list of WAN IP addresses/Subnets, that
the magic packet from these IP addresses/Subnets will be eligible to pass through NAT and
wake up the LAN client. You also need to set NAT rule for LAN client.
S
S
y
y
n
n
t
t
a
a
x
x
wol up [MAC Address]
wol fromWan [on/off/any]
wol fromWan_Setting [idx][ip address][mask]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
MAC Address It means the MAC address of the host.
on/off/any It means to enable or disable the function of WOL from WAN.
on: enable
off: disable
any: It means any source IP address can pass through NAT and wake
up the LAN client.
This command will allow the user to choose whether WoL packets
can be passed from the Internet to the LAN network from a specific
WAN interface.
[idx][ip address] [mask] It means the index number (from 1 to 4).
These commands will allow the user to configure the LAN clients
that the user may wake up from the Internet through the use of the
WoL packet.
ip address - It means the WAN IP address.
mask - It means the mask of the IP address.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wol fromWan on
> wol fromWan_Setting 1 192.168.1.45 255.255.255.0
>