Operation Manual
Vigor2133 Series User’s Guide
653
wan detect <wan1> target2 <ip addr>
wan detect <wan1> target_gw <1/0>
wan detect <wan1> interval <interval>
wan detect <wan1> retry <retry>
wan detect status
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
on Enable ping detection. The IP address of the target shall be set.
off Enable ARP detection (default).
always_on Disable link detect, always connected(only support static IP)
-t <time> Set the time setting. The default value is “30” and the range shall
be 1 to 255.
-i <Interval> Type the interval for the system to execute the PING operation. The
default value is “5” and it shall be smaller than time setting.
target <ip addr> Set the IP address for ping target.
target2 <ip addr> Set the secondary ping target.
target_gw <1/0> Set whether to use gateway as ping target. (1: yes 0: no)
Note that USB WAN (PPP mode) cannot support PING gateway
ttl <1-255> It means to set the ping TTL value (work as trace route)
If you do not set any value for ttl here or just type 0 here, the
system will use default setting (255) as the ttl value.
interval<Interval> Set the interval between each ping operation. Available setting is
between 1 and 3600. The unit is second.
interval: Type a value.
retry <retry> Set how many ping operations are retried before the Router judges
that the WAN connection is disconnected. Available setting is
between 1 and 255. The unit is times.
retry : Type a number.
status It means to show the current status.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> DrayTek> wan detect status
WAN1: off, send time=30, Interval = 5
WAN2: off, send time=30, Interval = 5
WAN3: off, send time=30, Interval = 5
WAN4: off, send time=30, Interval = 5
WAN5: off, send time=30, Interval = 5
WAN6: off, send time=30, Interval = 5>
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
a
a
n
n
m
m
v
v
l
l
a
a
n
n
This command allows you to configure multi-VLAN for WAN and LAN. It supports pure bridge
mode (modem mode) between Ethernet WAN and LAN port 2~4.
S
S
y
y
n
n
t
t
a
a
x
x
wan mvlan [pvc_no/status/save/enable/disable] [on/off/clear/tag tag_no] [service
type/vlan priority] [px ... ]
wan mvlan keeptag[pvc_no][on/off]