Operation Manual

Vigor2133 Series User’s Guide
638
off: disable.
remoteip
<Remote_Client_IP_Address
>
It means to assign the IP address for the remote client.
peer <Peer_ID> It means to assign the peer ID for such profile.
naming <pass/block> Pass – Click it to have an inquiry for data transmission between the
hosts located on both sides of VPN Tunnel while connecting.
Block – When there is conflict occurred between the hosts on both
sides of VPN Tunnel in connecting, it can block data transmission of
Netbios Naming Packet inside the tunnel.
multicastvpn <pass/block> Pass –Let multicast packets pass through the router.
Block – This is default setting. It can let multicast packets be
blocked by the router.
prekey <on/off> It means to enable/disable the pre-shared key for IKE
authentication method.
on: enable
off: disable.
assignkey <Pre_Shared_Key> Assign the pre-shared key.
Pre_Shared_Key – Type a string.
digsig <on/off> Enable /disable the function of Digital Signature (X.509) for IKE
authentication method.
ipsec <Method> <on/off> Set the IPsec security medthod for the specified VPN profile.
Method - 0:Medium(AH) High(ESP), 1:DES, 2:3DES, 3:AES
on / off - enable / disable.
localid <Local_ID> Assign a local ID to be used for Dial-in setting in the LAN-to-LAN
Profile setup.
Local_ID – Type a string.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> vpn dinset 1
Dial-in profile index 1
Profile Name: ???
Status: Deactive
Mobile OTP: Disabled
Password:
Idle Timeout: 300 sec
> vpn dinset 1 on
% set profile active
> vpn dinset 1 motp on
% Enable Mobile OTP mode!>
> vpn dinset 1 pin_secret 1234 e759bb6f0e94c7ab4fe6
> vpn dinset 1
Dial-in profile index 1
Profile Name: ???