Operation Manual
Vigor2133 Series User’s Guide
603
port (500) preservation.
status It means to display current status for checking.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> srv nat ipsecpass status
%% Status: IPsec ESP pass-thru and IKE src_port:500 preservation is OFF.
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
s
s
r
r
v
v
n
n
a
a
t
t
o
o
p
p
e
e
n
n
p
p
o
o
r
r
t
t
This command allows users to set open port settings for NAT server.
S
S
y
y
n
n
t
t
a
a
x
x
srv nat openport n m [-<command> <parameter> | … ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
n It means the index number for the profiles. The range is from 1 to
40.
m It means to specify the sub-item number for this profile. The range
is from 1 to 10.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-a <enable> It means to enable or disable the open port rule profile.
0: disable
1:enable
-c <comment> It means to type the description (less than 23 characters) for the
defined network service.
-i <local ip> It means to set the IP address for local computer.
Local ip: Type an IP address in this field.
-w <widx> <ipidx> It means to specify the public IP.
widx – means the WAN interface. In which,
1: WAN1 Default, 2: WAN1 Alias 1,….. 255: all WANs.
ipidx – means the index number (1 ~ 32) for all Alias IPs.
-p <protocol> Specify the transport layer protocol.
Available values are TCP, UDP and ALL.
-s<start port> It means to specify the starting port number of the service offered
by the local host. The range is from 0 to 65535.
-e<end port> It means to specify the ending port number of the service offered by
the local host.
The range is from 0 to 65535.
-v It means to display current settings.
-r <remove> It means to delete the specified open port setting.
remove: Type the index number of the profile.
-f <flush> It means to return to factory settings for all the open ports profiles.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> srv nat openport 1 1 -a 1 -c games -i 192.168.1.56 -w 1 1 -p TCP -s 23 -
e
83
> Set WAN Port ok!!