Operation Manual

Vigor2133 Series User’s Guide
582
TCP WWW Timeout: 60 sec.
TCP SYN Timeout: 60 sec.
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
p
p
p
p
a
a
This command allows you to configure PPA mode.
ppa [-<command> <parameter> | ... ]
ppa n [-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-m <mode> Specify a mode.
1=auto
2=manual(traffic)
3=manual(qos)
4=manual(specific hosts)
0=disable
-p <proto> Specify a protocol.
proto - 1-TCP; 2-UDP; 3-Both.
-b 1/0 Enable/disable TWO-way hardware acceleration.
-M enable/disable Enable/disable the multicast hardware acceleration.
-S Show multicast table in hardware acceleration.
-v <view> Show PPA_WAN_Table and PPA_LAN_Table for reference.
-c Clean all settings.
ppa n – used in QoS or specific host
-l <rule> Specify an index number of rule profile for QoS mode.
-h <host> Type an IP address for Specific Host mode.
-s <start port> Specify a starting port number for Specific Host mode.
-e <end port> Specify an ending port number for Specific Host mode
-x Show hardware acceleration information.
-k Clean the PPA table.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ppa -m 1 -p 1 -b 0
Set ok! The PPA mode is Auto
% You need to set the Manual mode first !
%TWO way accleration is disable
> ppa -v
% PPA mode is Auto
%PPA Protocol TCP 1, UDP 0
%PPA two way disable
%PPA time is 10
%PPA range is 192
%PPA LAN entries 0