Operation Manual
Vigor2133 Series User’s Guide
528
ip6 dhcp client [WAN1|WAN2|USB] [-<command> <parameter>| ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
client It means the dhcp client settings.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-a It means to show current DHCPv6 status.
-p [IAID] It means to request identity association ID for Prefix Delegation.
-n [IAID] It means to request identity association ID for Non-temporary
Address.
-t [time] It means to set solicit interval.
Time: 0 ~ seconds (default value is 0).
-c [parameter] It means to send rapid commit to server.
-I [parameter] It means to send information request to server.
-e[parameter] It means to enable or disable the DHCPv6 client.
1: Enable
0: Disable
-m [parameter] It means to enable/disable server DUID set by Link layer and time.
-d It means to display the client DUID.
-A [parameter] It means to set authentication protocol.
0: Undefine
2: delayed protocol
-R [parameter] It means to set realm value (max: 31 characters) in delayed
protocol.
-S [parameter] It means to set shared secret (max: 31 characters) in delayed
protocol.
-K [parameter] It means to set key ID (1~65535) in delayed protocol.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
> system reboot
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
i
i
p
p
6
6
d
d
h
h
c
c
p
p
s
s
e
e
r
r
v
v
e
e
r
r
This command allows you to configure DHCPv6 server.
S
S
y
y
n
n
t
t
a
a
x
x
ip6 dhcp server [-<command> <parameter>| ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n