Operation Manual

Vigor2133 Series User’s Guide

3. For adding a new rule, click Add to open the following page.

Available settings are explained as follows:

Item Description

ACT Check this box to invoke these settings.

Hardware

Acceleration

Check this box to enable the hardware acceleration when

such rule is applied.

Ethernet Type Please specify which protocol (IPv4 or IPv6) will be used for

this rule.

Local Address Click the Edit button to set the local IP address (on LAN) for

the rule.

Remote Address Click the Edit button to set the remote IP address (on

LAN/WAN) for the rule.

Address Type – Determine the address type for the source

address.

For Single Address, you have to fill in Start IP address.

For Range Address, you have to fill in Start IP address and

End IP address.

For Subnet Address, you have to fill in Start IP address and

Subnet Mask.

DiffServ CodePoint All the packets of data will be divided with different levels

and will be processed according to the level type by the

system. Please assign one of the levels of the data for

processing with QoS control.

Service Type It determines the service type of the data for processing with

QoS control. It can also be edited. You can choose the

predefined service type from the Service Type drop down

list. Those types are predefined in factory. Simply choose the

one that you want for using by current QoS.

4. After finishing all the settings here, please click OK to save the configuration.