Operation Manual

Vigor2133 Series User’s Guide
15
9
IP Subnet – Define a subnet containing IP address and mask
address.
 Network – Type an IP address here.
 Mask – Use the drop down list to choose a suitable mask
for the network.
IP Object / IP Group – Choose an IP object / IP group.
Destination Port Any – Any port number can be treated as the destination
port.
Dest Port Range – A range of port number can be treated as
the destination port.
 Start - Type the destination port start for the
destination IP.
 End - Type the destination port end for the destination
IP. If this field is blank, it means that all the
destination ports will be passed through the WAN
interface.
Send to if criteria
matched
Interface – Use the drop down list to choose a WAN or LAN
interface or VPN profile. Packets match with the above
criteria will be transferred to the interface chosen here.
Gateway IP – Specific gateway is used only when you want
to forward the packets to the desired gateway. Usually,
Default Gateway is selected in default.
Packet Forwarding to WAN via – When you choose WAN
(e.g., WAN1) as the Interface for packet transmission, you
have to specify the way the packet forwarded to. Choose
Force NAT or Force Routing.
Failover to – Check this button to lead the data passing
through specific interface (WAN/LAN/VPN/Route Policy)
automatically when the selected interface (defined in Send
via if criteria matched) is down.
 WAN/LAN – Use the drop down list to choose an
interface as an auto failover interface.
 VPN – Use the drop down list to choose a VPN tunnel as
a failover tunnel.
 Route Policy – Use the drop down list to choose an
existed route policy profile.
Gateway IP – Specific gateway is used only when you want
to forward the packets to the desired gateway. Usually,
Default Gateway is selected in default.
Priority Packets will be transmitted based on all routes or Route
Policy. Vigor router will determine which rule will be
adopted for transmitting the packet according to the
priority of Static Route and Route Policy.
The greater the value is, the lower the priority is. Default
value for route policy is “200” which means it has higher
priority than the default route.
3. When you finish the configuration, please click OK to save and exit this page.
I
I
I
I
-
-
6
6
-
-
2
2
-
-
2
2
D
D
i
i
a
a
g
g
n
n
o
o
s
s
e
e
With the analysis done by such page, possible path (static route, routing table or policy route)
of the packets sent out of the router can be traced.