Operation Manual
Vigor2133 Series User’s Guide
88
Delete – Click it to remove an existed entry.
Unique Local Address
(ULA) configuration
Unique Local Addresses (ULAs) are private IPv6 addresses
assigned to LAN clients.
Off - ULA is disabled.
Manually ULA Prefix - LAN clients will be assigned ULAs
generated based on the prefix manually entered.
Auto ULA Prefix - LAN clients will be assigned ULAs using an
automatically-determined prefix.
Current IPv6 Address
Table
Display current used IPv6 addresses.
DNS Server IPv6 Address Deploy when WAN is up – The RA (router advertisement)
packets will be sent to LAN PC with DNS server information
only when network connection by any one of WAN interfaces
is up.
Enable – The RA (router advertisement) packets will be sent
to LAN PC with DNS server information no matter WAN
connection is up or not.
Primary DNS Sever – Type the IPv6 address for Primary
DNS server.
Secondary DNS Server –Type another IPv6 address for
DNS server if required.
Disable – DNS server will not be used.
Management Configures the Managed Address Configuration flag (M-bit) in
Route Advertisements.
Off - No configuration information is sent using Route
Advertisements.
SLAAC(stateless) - M-bit is unset.
DHCPv6(stateful) - M-bit is set, which indicates to LAN
clients that they should acquire all IPv6 configuration
information from a DHCPv6 server. The DHCPv6 server
can either be the one built into the Vigor2860, or a
separate DHCPv6 server.
Other Option(O-bit) When selected, the Other Configuration flag is set, which
indicates to LAN clients that IPv6 configuration information
besides LAN IPv6 addresses is available from a DHCPv6
server.
Setting the M-bit (see Management above) has the same
effect as implicitly setting the O-bit, as DHCPv6 supplies all
IPv6 configuration information, including what is indicated as
available when the O-bit is set.
DHCPv6 Server Enable Server –Click it to enable DHCPv6 server. DHCPv6
Server could assign IPv6 address to PC according to the
Start/End IPv6 address configuration.