Operation Manual

Vigor2132 Series User’s Guide
184
web page.
Enable
Check this box to enable this policy.
Protocol
Display the protocol used for this policy.
Interface
Display the interface to send packets to once the policy is
matched.
Interface Address
Display the IP address of the selected interface.
Src IP Start
Display the IP address for the start of the source IP.
Src IP End
Display the IP address for the end of the source IP.
Dest IP Start
Display the IP address for the start of the destination IP.
Dest IP End
Display the IP address for the end of the destination IP.
Dest Port Start
Display the IP address for the start of the destination port.
Dest Port End
Display the IP address for the end of the destination port.
Move UP/Move Down
Use Up or Down link to move the order of the policy.
Wizard Mode
Allow to configure frequently used settings of route policy
via three setting pages
Advance Mode
Allow to configure detailed settings of route policy.
To use Wizard Mode, simple do the following steps:
1. Click the Wizard Mode radio button.
2. Click any Index number link (e.g., 2 in this case). The setting page will appear as follows:
Available settings are explained as follows:
Item Description
Source IP
Any – Any IP can be treated as the source IP.
Src IP Start - Type the source IP start for the specified
WAN interface.
Src IP End - Type the source IP end for the specified
WAN interface. If this field is blank, it means that all the
source IPs inside the LAN will be passed through the WAN