Operation Manual

Vigor2132 Series User’s Guide
5
1
1
.
.
2
2
.
.
2
2
V
V
i
i
g
g
o
o
r
r
2
2
1
1
3
3
2
2
a
a
c
c
/
/
V
V
a
a
c
c
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On USB device is connected and ready for use. USB1~USB2
Blinking The data is transmitting.
On Internet connection is ready.
Off Internet connection is not ready.
WAN
Blinking The data is transmitting.
On Wireless access point with bandwidth of 2.4GHz/5GHz
is ready.
2.4G/5G
Blinking It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
CSM
On The profile(s) of CSM (Content Security Management)
for IM/P2P, URL/Web Content Filter application can
be enabled from Firewall >>General Setup. (Such
profile must be established under CSM menu).
On The DoS function is active. DoS
Blinking It will blink while detecting an attack.
QoS
On The QoS function is active.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Phone1 ~ Phone2
Blinking A phone call comes.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
WAN
Right
LED
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
LAN1~
LAN4
Right
LED
Off The port is connected with 10/100Mbps