User`s guide

Vigor2130 Series User’s Guide
39
Modem Dial String Such value is used to dial through USB mode. Please use the
default value. If you have any question, please contact to your
ISP.
PPP Username Type the PPP username (optional).
PPP Password Type the PPP password (optional).
Clone MAC Address It is available when the box of Enable is checked. Click Clone
MAC Address. The result will be displayed in the field of
MAC Address.
After finishing all the settings here, please click OK to activate them.
3
3
.
.
1
1
.
.
2
2
P
P
o
o
r
r
t
t
s
s
Ports page is used to change the setting for WAN port. You can set or reset the following
items. All of them are described in detail below.
Port It displays current network interface.
Link It displays current connection status. Green light means the
WAN connection is successful.
Current It displays current speed that the router uses.
Speed Configured It can set the speed and duplex of the port. You can use the drop
down list to choose the required speed for the router. If you
have no idea in configuring speed, simple use the default setting,
Auto.
Flow Control If flow control is enabled by checking Configured box, both
parties can send PAUSE frame to the transmitting device(s) if
the receiving port is too busy to handle. If not, there will be no
flow control in the port. It drops the packet if too much to
handle.
Current Rx: indicates whether pause frames on the port are