Operation Manual

Vigor2120 Series User’s Guide
189
enable “Always pass inbound…”. By checking this box,
you can play these kinds of on-line games. If security
concern is in higher priority, you cannot enable “Always
pass inbound”.
Enable Strict Security
Firewall
For the sake of security, the router will execute strict
security checking for data transmission.
Such feature is enabled in default. All the packets, while
transmitting through Vigor router, will be filtered by
firewall. If the firewall system (e.g., content filter server)
does not make any response (pass or block) for these
packets, then the router’s firewall will block the packets
directly.
Block routing connections
initiated from WAN
Usually, IPv6 network sessions/traffics from WAN to LAN
are allowed in default.
IPv6 - Check the box to make the packets (routed from
WAN to LAN) via IPv6 being blocked by such router. It is
effective only for the packets routed but not for packets
translated by NAT.
IPv4 - Check the box to make the incoming packets via
IPv4 being blocked by such router. It is effective only for
the packets routed but not for packets translated by NAT.
Backup Firewall
Click Backup to save the firewall configuration.
Restore Firewall
Click Select to choose a firewall configuration file. Then
click Restore to apply the file.