Operation Manual

Vigor2110F Series User’s Guide

RIP Protocol Routing Information Protocol is abbreviated as RIP（RFC1058）

specifying how routers exchange routing tables information. Click

Enable RIP for activating this function.

WAN Backup Setup 3G USB Modem – If you install a 3G USB modem on the router,

please Enable the Dial Backup Mode to perform file backup via

USB device. After choosing Enable, please click the 3G USB

Modem link to access into the following page for configuring

detailed settings.

PPP Client Mode - Click Enable to activate this mode for WAN2.

SIM PIN code - Type PIN code of the SIM card that will be used to

access Internet.

Modem Initial String - Such value is used to initialize USB modem.

Please use the default value. If you have any question, please contact

to your ISP.

APN Name - APN(Access Point Name) is provided by your ISP for

identifying different access points. Simply click Apply to apply such

name. Finally, you have to click OK to save the setting.

Apply – Activate the function of identification.

Modem Dial String - Such value is used to dial through USB mode.

Please use the default value. If you have any question, please contact

to your ISP.

PPP Username - Type the PPP username (optional).

PPP Password - Type the PPP password (optional).

WAN IP Network

Settings

This group allows you to obtain an IP address automatically and

allows you type in IP address manually.

WAN IP Alias - If you have multiple public IP addresses and would

like to utilize them on the WAN interface, please use WAN IP Alias.

You can set up to 8 public IP addresses other than the current one

you are using.