Operation Manual

Vigor2110F Series User’s Guide
178
phase 2 quick mode.
More Add a static route to direct all traffic destined to more Remote
Network IP Addresses/ Remote Network Mask through the
VPN connection. This is usually used when you find there are
several subnets behind the remote VPN router.
RIP Direction The option specifies the direction of RIP (Routing Information
Protocol) packets. You can enable/disable one of direction here.
Herein, we provide four options: TX/RX Both, TX Only, RX
Only, and Disable.
From first subnet to
remote network, you
have to do
If the remote network only allows you to dial in with single
IP, please choose NAT, otherwise choose Route.
Change default route to
this VPN tunnel
Check this box to change the default route with this VPN
tunnel.