Operation Manual

Vigor2110F Series User’s Guide
173
Profile Name Specify a name for the profile of the LAN-to-LAN connection.
Enable this profile Check here to activate this profile.
Netbios Naming Packet Pass – click it to have an inquiry for data transmission between
the hosts located on both sides of VPN Tunnel while connecting.
Block – When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
block data transmission of Netbios Naming Packet inside the
tunnel.
Call Direction Specify the allowed call direction of this LAN-to-LAN profile.
Both:-initiator/responder
Dial-Out- initiator only
Dial-In- responder only.
Always On or Idle Timeout Always On-Check to enable router always keep VPN
connection.
Idle Timeout: The default value is 300 seconds. If the
connection has been idled over the value, the router will drop
the connection.
Enable PING to keep alive This function is to help the router to determine the status of
IPSec VPN connection, especially useful in the case of
abnormal VPN IPSec tunnel disruption. For details, please refer
to the note below. Check to enable the transmission of PING
packets to a specified IP address.