User`s guide

Vigor2110 Series User’s Guide
186
None - Do not apply the IPSec policy. Accordingly, the VPN
connection employed the L2TP without IPSec policy can be
viewed as one pure L2TP connection.
Nice to Have - Apply the IPSec policy first, if it is applicable
during negotiation. Otherwise, the dial-in VPN connection
becomes one pure L2TP connection.
Must - Specify the IPSec policy to be definitely applied on the
L2TP connection.
Specify Remote VPN
Gateway
You can specify the IP address of the remote dial-in user or
peer ID (should be the same with the ID setting in dial-in
type) by checking the box. Also, you should further specify
the corresponding security methods on the right side.
If you uncheck the checkbox, the connection type you select
above will apply the authentication methods and security
methods in the general settings.
User Name This field is applicable when you select PPTP or L2TP with or
without IPSec policy above.
Password This field is applicable when you select PPTP or L2TP with or
without IPSec policy above.
VJ Compression VJ Compression is used for TCP/IP protocol header
compression. This field is applicable when you select PPTP or
L2TP with or without IPSec policy above.
IKE Authentication
Method
This group of fields is applicable for IPSec Tunnels and
L2TP with IPSec Policy when you specify the IP address of
the remote node. The only exception is Digital Signature
(X.509) can be set when you select IPSec tunnel either with
or without specify the IP address of the remote node.
Pre-Shared Key - Check the box of Pre-Shared Key to
invoke this function and type in the required characters
(1-63) as the pre-shared key.
Digital Signature (X.509) –Check the box of Digital
Signature to invoke this function and select one predefined
Profiles set in the VPN and Remote Access >>IPSec Peer
Identity.
IPSec Security Method This group of fields is a must for IPSec Tunnels and L2TP with
IPSec Policy when you specify the remote node.
Medium- Authentication Header (AH) means data will be
authenticated, but not be encrypted. By default, this option is
active.
High- Encapsulating Security Payload (ESP) means payload
(data) will be encrypted and authenticated. You may select
encryption algorithm from Data Encryption Standard (DES),
Triple DES (3DES), and AES.
My WAN IP This field is only applicable when you select PPTP or L2TP
with or without IPSec policy above. The default value is 0.0.0.0,
which means the Vigor router will get a PPP IP address from
the remote router during the IPCP negotiation phase. If the PPP
IP address is fixed by remote side, specify the fixed IP address
here. Do not change the default value if you do not select PPTP
or L2TP.