User`s guide

Vigor2110 Series User’s Guide
96
PPP Client Mode - Click Enable to activate this mode for WAN2.
SIM PIN code - Type PIN code of the SIM card that will be used to
access Internet.
Modem Initial String - Such value is used to initialize USB modem.
Please use the default value. If you have any question, please contact
to your ISP.
APN Name – APN (Access Point Name) is provided by your ISP
for identifying different access points. Simply click Apply to apply
such name. Finally, you have to click OK to save the setting.
Apply – Activate the function of identification.
Modem Dial String - Such value is used to dial through USB mode.
Please use the default value. If you have any question, please contact
to your ISP.
PPP Username - Type the PPP username (optional).
PPP Password - Type the PPP password (optional).
PPP Authentication – Select PAP only or PAP or CHAP for PPP.
Index (1-15) in Schedule Setup - You can type in four sets of time
schedule for your request. All the schedules can be set previously in
Application – Schedule web page and you can use the number that
you have set in that web page.
PPP/MP Setup PPP Authentication – Select PAP only or PAP or CHAP for PPP.
If you want to connect to Internet all the time, you can check
Always On.
Idle Timeout – Set the timeout for breaking down the Internet after
passing through the time without any action.
IP Address
Assignment Method
(IPCP)
Usually ISP dynamically assigns IP address to you each time you
connect to it and request. In some case, your ISP provides service
to always assign you the same IP address whenever you request.
In this case, you can fill in this IP address in the Fixed IP field.
Please contact your ISP before you want to use this function.