Operation Manual

Vigor160 Series User’s Guide
43
VCI - Type in the value provided by your ISP.
Protocol - Select a proper protocol for this channel.
Encapsulation - Choose a proper type for this channel. The
types will be different according to the protocol setting that
you choose.
Add VLAN Header – Check the box to enable VLAN tag
configuration.
VLAN Tag – Type the value as the VLAN ID number. Valid
settings are in the range from 1 to 4095. The network traffic
flowing on each channel will be identified by the system via
their VLAN Tags. Channels using the same WAN type may not
configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
ATM QoS Such configuration is applied to upstream packets. Such
information will be provided by ISP. Please contact with your
ISP for detailed information.
QoS Type - Select a proper QoS type for the channel.
PCR - It represents Peak Cell Rate. The default setting is “0”.
SCR - It represents Sustainable Cell Rate. The value of SCR
must be smaller than PCR.
MBS - It represents Maximum Burst Size. The range of the
value is 10 to 50.
Open Port-based Bridge
Connection for this
Channel
The settings here will create a bridge between the LAN ports
selected and the WAN. The WAN interface of the bridge
connection will be built upon the WAN type selected using
the VLAN tag configured.
Physical Members – Group the physical ports by checking the
corresponding check box(es) for applying the port-based
bridge connection.
Note: LAN port P1 is reserved for NAT use and cannot be
selected for bridging.
Open WAN Interface for
this Channel
Check the box to enable relating function.
WAN Application
 Management can be specified for general management
(Web configuration/telnet/TR069). If you choose
Management, the configuration for this VLAN will be
effective for Web configuration/telnet/TR069.