Operation Manual

Vigor160 Series User’s Guide
9
4
Info There are two reasons that we have to apply RIP Protocol Control on
1st Subnet. The first is that the LAN interface can exchange RIP
packets with the neighboring routers via the 1st subnet
(192.168.1.0/24). The second is that those hosts on the internal
private subnets (ex. 192.168.10.0/24) can access the Internet via the
router, and continuously exchange of IP routing information with
different subnets.
2. Click the Routing >> Static Route and click on the Index Number 1. Check the Enable
box. Please add a static route as shown below, which regulates all packets destined to
192.168.10.0 will be forwarded to 192.168.1.2. Click OK.
Available settings are explained as follows:
Item Description
Enable Click it to enable this profile.
Destination IP
Address
Type an IP address as the destination of such static route.
Subnet Mask Type the subnet mask for such static route.
Network Interface Use the drop down list to specify an interface for such
static route.
3. Return to Static Route Setup page. Click on another Index Number to add another
static route as show below, which regulates all packets destined to 211.100.88.0 will be
forwarded to 192.168.1.3. Click OK.