Operation Manual

Vigor160 Series User’s Guide
93
Index The number (1 to 30) under Index allows you to open next
page to set up static route.
Enable Check the box to enable such route.
Destination Address Displays the destination address of the static route.
Backup Click it to backup current settings of static route as a file.
Restore Click it to restore static route configuration file.
A
A
d
d
d
d
S
S
t
t
a
a
t
t
i
i
c
c
R
R
o
o
u
u
t
t
e
e
s
s
t
t
o
o
P
P
r
r
i
i
v
v
a
a
t
t
e
e
a
a
n
n
d
d
P
P
u
u
b
b
l
l
i
i
c
c
N
N
e
e
t
t
w
w
o
o
r
r
k
k
s
s
Here is an example (based on IPv4) of setting Static Route in Main Router so that user A and B
locating in different subnet can talk to each other via the router. Assuming the Internet
access has been configured and the router works properly:
 use the Main Router to surf the Internet.
 create a private subnet 192.168.10.0 using an internal Router A (192.168.1.2)
 create a public subnet 211.100.88.0 via an internal Router B (192.168.1.3).
 have set Main Router 192.168.1.1 as the default gateway for the Router A 192.168.1.2.
Before setting Static Route, user A cannot talk to user B for Router A can only forward
recognized packets to its default gateway Main Router.
1. Go to LAN page and click General Setup, select 1st Subnet as the RIP Protocol Control.
Then click the OK button.