User`s guide

Vigor2760 Series User’s Guide
81
When you finish the configuration, please click OK to save and exit this page.
D
D
e
e
t
t
a
a
i
i
l
l
s
s
P
P
a
a
g
g
e
e
f
f
o
o
r
r
L
L
A
A
N
N
1
1
–
–
I
I
P
P
v
v
6
6
S
S
e
e
t
t
u
u
p
p
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on
IPv4) and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information. Below shows the settings page for IPv6.
It provides 2 daemons for LAN side IPv6 address configuration. One is RADVD(stateless)
and the other is DHCPv6 Server (Stateful).
Available settings are explained as follows:
Item Description
Router Advertisement
Server
Enable – Click it to enable router advertisement server. The
router advertisement daemon (radvd) sends Router
Advertisement messages, specified by RFC 2461, to a local
Ethernet LAN periodically and when requested by a node
sending a Router Solicitation message. These messages are
required for IPv6 stateless auto-configuration.
Disable – Click it to disable RADVD server.
Advertisement Lifetime - The lifetime associated with the
default router in units of seconds. It's used to control the
lifetime of the prefix. The maximum value corresponds to
18.2 hours. A lifetime of 0 indicates that the router is not a