Operation Manual

Vigor1000 Series User’s Guide
87
Static MAC Table
Config..
Specify static MAC address with VLAN ID to apply aging
configuration.
Delete - Click the button to remove the VLAN setting.
LAN ID - Specify the interface for the port members.
MAC Address - It is a six-byte long Ethernet hardware
address and usually expressed by hex and separated by
hyphens. For example, 00 – 40 - C7 - D6 – 00 – 02.
WAN/LAN1~4 - Check the port to apply this VLAN
setting.
To add a new static MAC entry, click Add New Static Entry. A new entry will be shown as
follows. Choose a VLAN ID and type a new MAC address. Next, specify port member for
this table. Finally, click OK to save the changes.
4
4
.
.
2
2
.
.
4
4
V
V
L
L
A
A
N
N
Virtual LAN function provides you a very convenient way to manage hosts by grouping them
based on the physical port. You can also manage the in/out rate of each port. Go to LAN page
and select VLAN. The following page will appear. VLAN function is enabled in default.
Available settings are explained as follows:
Item Description
Add New Private VLAN
Click this button to add a new private VLAN. The router
allows you to add up to 4 VLAN