Operation Manual

Vigor1000 Series User’s Guide
84
4
4
.
.
2
2
.
.
2
2
P
P
o
o
r
r
t
t
s
s
Ports page is used to change the setting for LAN ports. You can set or reset the following
items. All of them are described in detail below.
Available settings are explained as follows:
Item Description
Port
It displays current network interface.
Link
It displays current connection status. Green light means the
WAN connection is successful.
Speed Current
It displays current speed that the router uses.
Speed Configured
You can use the drop down list to choose the required speed
for the router. If you have no idea in configuring speed,
simple use the default setting, Auto.
Flow Control
If flow control is enabled by checking Configured box,
both parties can send PAUSE frame to the transmitting
device(s) if the receiving port is too busy to handle. If not,
there will be no flow control in the port. It drops the packet
if too much to handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
Current Tx: indicates whether pause frames on the port are
transmitted.
Maximum Frame
This module offers 1518~9600 (Bytes) length to make the
long packet for data transmission.