Operation Manual

Vigor1000 Series User’s Guide
41
3. Select Dial-in as Call Direction.
4. In Dial-Out Settings part, select IPSec Tunnel and press the Advanced button.
5. In the pop-up window please enter vigor2820 in the Local ID field. Click OK to return
to the profile setting page.
6. In Dial-In Settings part, please enable Specify Remote VPN Gateway and enter
Vigor1000 in the Peer ID field.
7. Setup a pre-shared key, which must be the same as in Vigor1000.
8. Enter Vigor1000’s private network in the Remote Network IP / Mask field.
9. Click OK.
Note: Vigor1000 supports the following proposals by default.
For phase 1,
Mode Selection Proposals will be sent
When you select Automatic 3DES, SHA1, Group 2
When you select 3DES 3DES, MD5, Group 5
When you select AES(any) AES, MD5, Group 5
When you select AES-128 AES-128, MD5, Group 5
When you select AES-192 AES-192, MD5, Group 5
When you select AES-256 AES-256, MD5, Group 5
For phase 2,
Mode Selection Proposals will be sent
When you select Automatic AES-128, MD5; AES-128, SHA1;
AES-192, MD5; AES-192, SHA1;
AES-256, MD5; AES-256, SHA1;
3DES, SHA1; 3DES, MD5
When you select 3DES 3DES, MD5; 3DES, SHA1
When you select AES(any) AES-256, MD5; AES-256, SHA1
When you select AES-128 AES-128, MD5; AES-128, SHA1
When you select AES-192 AES-192, MD5; AES-192, SHA1
When you select AES-256 AES-256, MD5; AES-256, SHA1