Operation Manual

Vigor1000 Series User’s Guide
215
Available settings are explained as follows:
Item Description
User Name
Type the name obtained from the broker. “Vigor1000” is a
default username applied from
http://go6.net/4105/register.asp
. It is suggested for you to
apply another username and password.
Password
Type the password assigned with the user name.
Confirm Password
Type the password again to make the confirmation.
Tunnel Broker
Type the address for the tunnel broker IP, FQDN or an
optional port number.
Tunnel Mode
IPv6-in-IPv4 Tunnel- Let the broker chose the tunnel
mode appropriate for the client.
IPv6-in-IPv4 (Native) - Request an IPv6 in IPv4 tunnel.
IPv6-in-IPv4 (NAT Traversal - Request an IPv6 in UDP
of IPv4 tunnel (for clients behind a NAT).
Auto-reconnect Delay
After passing the time set here, the client will retry to
connect in case of failure or keepalive timeout.
0 means not retry.
Keepalive
Yes – Keep the connection between TSPC and tunnel
broker always on. TSPC will send ping packet to make
sure the connection between both ends is normal.
No - The client will not send keepalives.