Operation Manual

Vigor1000 Series User’s Guide
159
A
A
d
d
d
d
i
i
n
n
g
g
a
a
V
V
P
P
N
N
T
T
u
u
n
n
n
n
e
e
l
l
f
f
o
o
r
r
P
P
P
P
T
T
P
P
Click Add Tunnel to open the following page.
Available settings are explained as follows:
Item Description
Dial-Out General Setting
Enabled - Check here to activate this tunnel.
Always On - Check this box to make the WAN connection
being activated always.
Name - Specify a name for this tunnel.
Remote IP - Enter the IP address/name of the remote host
that located at the other-end of the VPN tunnel.
Authentication
User Name - Type a name for this tunnel for
authentication.
Password - Type a password for this tunnel for
authentication.
MPPE - Check this box to enable the function of MPPE
for such tunnel.
Networks
Local Network / Mask - Traffic between this subnet and
the subnet specified in Remote Network / Mask will travel
through the VPN tunnel.
Remote Network / Mask - Add a static route to direct all
traffic destined to this Remote Network IP
Address/Remote Network Mask through the VPN