Operation Manual

Vigor1000 Series User’s Guide
155
4
4
.
.
8
8
.
.
5
5
L
L
A
A
N
N
t
t
o
o
L
L
A
A
N
N
Here you can manage LAN-to-LAN connections by maintaining a table of connection profiles.
You may set parameters including specified connection peer ID, connection type and
corresponding security methods, etc.
The router supports two VPN tunnels for IPSec and PPTP by providing up to 2 profiles. The
following figure shows the summary table.
Available settings are explained as follows:
Item Description
Auto-refresh Check this box to make the system refresh this page
automatically.
Refresh
Click this button to refresh the page immediately.
Name
Indicate the name of the LAN-to-LAN profile.
Endpoint
Display the IP address of the VPN client.
IKE Alg
Display the encryption and authentication algorithm used
during phase 1 of the VPN connection Establishment. The
algorithm is used during exchange of key exchange.
ESP Alg
Display the encryption and authentication algorithm used
during phase 2 of the VPN connection Establishment. This
algorithm is used for transporting data, and the choice will
affect the performance of the VPN tunnel.
Tx Packets / Tx Bytes
Display the data transmission packets / bytes through VPN
tunnel (by IPSec or PPTP).
Rx Packets / Rx Bytes
Display the data receiving packets / bytes through VPN
tunnel (by IPSec or PPTP).
Up Time
Display the duration time of the IPSec / PPTP connection.
Add Tunnel
Click it to add a new VPN tunnel via IPSec / PPTP
protocol.