Operation Manual

Vigor1000 Series User’s Guide
152
4
4
.
.
8
8
.
.
3
3
I
I
P
P
S
S
e
e
c
c
R
R
e
e
m
m
o
o
t
t
e
e
D
D
i
i
a
a
l
l
-
-
i
i
n
n
This page allows you to configure IPSec Site-to-Client settings.
Available settings are explained as follows:
Item Description
Mobile VPN Type
This usually applies to those are remote dial-in user or
node (LAN-to-LAN) which uses dynamic IP address and
IPSec-related VPN connections such as L2TP over IPSec
and IPSec tunnel.
Disabled – Ignore the configurations set in this page.
Dynamic VPN (IPSec) – Traffic between this subnet and
the client will travel through the VPN tunnel. If you choose
this type, please specify the IP address and subnet mask for
local network.
L2TP/IPSec –The range must not overlap the DHCP
address range (if enabled), and must allow for at least one
IP address. Example: 10.10.137.240-10.10.137.245. If you
choose this type, please specify the IP address range for
L2TP/IPSec mode.