Operation Manual

Vigor1000 Series User’s Guide
92
Available settings are explained as follows:
Item Description
Enable
Check this box to enable this policy route.
Source IP Address
Type the source address of the policy route.
Subnet Mask
Type the subnet mask for the source IP address.
Destination Address
Display the destination address of the policy route.
Subnet Mask
Type the subnet mask for the destination IP address.
Gateway IP Address
Display the IP address of the gateway.
Interface
Choose one of the options as the interface for such policy
route.
Do NAT for Source Subnet – This option is not available
for LAN interface. If tt is enabled, the data from Source IP
address will be transmitted into the WAN IP/VoIP
WAN/IPTV WAN/Management WAN address of the
router.
Click OK to save the settings.
4
4
.
.
2
2
.
.
8
8
B
B
i
i
n
n
d
d
I
I
P
P
t
t
o
o
M
M
A
A
C
C
This function is used to bind the IP and MAC address in LAN to have a strengthening control
in network. When this function is enabled, all the assigned IP and MAC address binding
together cannot be changed. If you modified the binding IP or MAC address, it might cause
you not access into the Internet.
Click LAN and click Bind IP to MAC to open the setup page.