User's Manual

4
Blinking The data is transmitting.
Right LED
(Green)
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps.
Interface Description
Factory Reset Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and
keep for more than 5 seconds. When you see the ACT LED begins to
blink rapidly than usual, release the button. Then the router will
restart with the factory default configuration.
Wireless LAN
ON/OFF/WPS
WLAN On - Press the button and release it within 2 seconds. When
the wireless function is ready, the green LED will be on.
WLAN Off - Press the button and release it within 2 seconds to turn
off the WLAN function. When the wireless function is not ready, the
LED will be off.
WPS - When WPS function is enabled by web user interface, press
this button for more than 2 seconds to wait for client’s device making
network connection through WPS.
Fiber Connector for accessing the Internet.
WAN1~WAN2 Connector for remote networked devices.
LAN1~LAN4 Connectors for local networked devices.
USB1~USB2 Connector for a USB device (for 3G/4G USB Modem or printer).
PWR Connector for a power cord.
ON/OFF
Power Switch.
Note Vigor router will use either Fiber WAN or WAN1 for Internet connection. If
both Fiber WAN and WAN1 are connected at the same time, Fiber WAN will
be the first choice.