Quick Start Guide

2.2
2.2
Vigor286
Vigor286
5ac/Vigor2866ac
5ac/Vigor2866ac
LED Status Explanation
ACT Off The router is powered off.
Blinking The router is powered on and running
normally.
WAN2 On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
QoS On The QoS function is active.
Off The QoS function is inactive.
USB On USB device is connected and ready for use.
Off No USB device is connected.
Blinking The data is transmitting.
DSL On The router is ready to access Internet
through DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
WCF On The Web Content Filter is active. (It is
enabled from Firewall >> General Setup).
Off WCF is disabled.
2.4G/5G
On
2.4G/5G: Wireless access point with
bandwidth of 2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
Off Wireless function is disabled.
Blinking
It will blink slowly while wireless traffic goes
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
DMZ On The DMZ function is enabled.
Off The DMZ function is disabled.
Blinking The data is transmitting.
LED on Connector
WAN2
/ P6
Left
LED
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
5