Owners Manual

DRAWMER

INSTALLATION

The MC3.1 is a free standing, desktop unit, with controls and headphone jacks on

the front panel and all other inputs and outputs on the rear.

Screwing the MC3.1 to a desk.

Rather than having the MC3.1 free standing it can be fastened down to a desk by

utilising the holes that hold the rubber feet to the underside. Note that when fixing

to a desk the speaker trims on the base of the unit will not be accessible and so the

calibration procedure should be carried out before fastening the MC3.1 in place

(see ‘Monitor Calibration’).

Drill four holes into the desk, at

4mm in diameter and to th e

dimensions as shown in th e

diagram. (Note that in the

diagram th e MC3.1 is viewed

from above).

Pushing four screws through the undersid

of th e desk screw th e

MC3.1, including the rubber feet,

to th e panel to secure. The

screws should be M3 and have a

length of 14 mm plus the

thickness of the panel.

Compare the MC2.1 and MC3.1 Features