Owners Manual

DRAWMER

INSTALLATION

The MC1.1 is a free standing, desktop unit, with controls and headphone jacks on

the front panel and all other inputs and outputs on the rear. Multiple units can be

stacked whilst sitting on the desk, however, the MC1.1 can be screwed to the desk

or into a standard 19” rack (using a 2U mounting kit).

Screwing the MC1.1 to

a desk.

Rather than having the

MC1.1 free standing it

can be fastened down to

a desk by utilising the

holes that hold the

rubber feet to the

underside.

Drill four holes into the

desk, at 4mm in

diameter and to the

dimensions as shown in

the diagram. (Note that

the diagram is viewed

from above).

Pushing four screws

through the under-side

of the desk screw the

MC1.1, including the

rubber feet, to the panel

to secure. The screws

should be M3 and have

a length of 14mm plus

the thickness of the panel.

Should the MC1.1 be fitted into a rack using the optional 2U rack mounting kit, where

possible, avoid mounting the unit directly above power amplifiers or power supplies

that radiate significant amounts of heat.

If the unit is to be used in a mobile situation, it is strongly recommended that the rear

of the unit is supported in the carrying rack to avoid bending the front panel rack

mounting ‘ears’. Use fibre or plastic washers to prevent the front panel becoming

marked by the mounting bolts. Always connect the mains earth to the unit.