Owners Manual

MC1.1 - Monito r Pre-Amp

OUTPUTS

Two stereo balanced speaker outputs- A and B, plus a dedicated mono speaker/

sub-woofer output - MONO - are found on the rear of the unit. A and MONO in the form

of Neutrik 3 pin XLR’s and B utilises RCA connectors.

Each output is activated by the Speakers switches (see ) - and can be activated

individually or simultaneously.

If connecting the A Mono/Sub output to a subwoofer bear in mind that the stereo

signal is monogised but contains the signal’s full frequency range. Any low pass

filtering, volume level, subsonic filtering etc. should be performed by the subwoofer

itself (or external crossover box).

MAINS I.E.C. AND POWER SWITCH

The MC1.1 is fitted with an internal toroidal linear power supply to provide low

amounts of hum and a professional level of headroom.

The mains inlet, I.E.C., which also incorporates the internal mains fuse, can be

found on the rear of the unit. A mains lead will have been provided with the MC1.1

to suit the mains configuration for the country of your purchase.

The power switch is located above the I.E.C. and is used to switch the unit on and

off. This is a hard boot switch (as opposed to a soft stand-by switch) and so when

in the off position the MC1.1 will draw no mains power.

Note that a timed relay protection circuit has been incorporated into the MC1.1 to

prevent bangs and other potentially harmful artifacts from occurring during power up

and power down.