Owners Manual

MC1.1 - Monito r Pre-Amp

MONITOR VOLUME

The Monitor Volume control adjusts the signal level of both stereo channels for all

speaker outputs. The Volume knob affects the volume of the monitors A (plus the

mono) & B only and does not have a bearing on the headphones.

The volume knob circuit design incorporates a parallelled custom quad

potentiometer, for excellent channel matching and a smooth feel, with a range from

Off (-infinity) to +6dB of gain.

Because the circuitry is active it allows for the signal level to be increased, unlike

some devices that can only attenuated, making subtle problems within a mix (such

as noise at low levels, or unwanted harmonics, for example) more obvious and

easier to iron out, especially during musical passages that would normally be

quiet.

WARNING:

It is recommended that you turn the volume control down to a lower level before

turning the MC1.1 off - this is to ensure that a sudden volume increase when

turning on does not damage your speakers or your hearing

In addition, do not use excessive force at either end of the volume knob - it’s

size would mean that damaging the potentiometer is possible.

HEADPHONES

The MC1.1 has a dedicated headphone output, via 1/4” TRS jack, with individual

headphone amplifier and level control - Note that the level control is not affected by

the main large monitor volume knob , and have no baring on volume of the rear

panel outputs .

Just like the main volume control the headphone knob circuit design incorporates

a parallelled custom quad potentiometer, for excellent channel matching and a

smooth feel across the entire rotation.

Warning:

It is advisable to unplug the headphones before switching the MC1.1 on or off.

It is also recommended that you turn the headphone level down before inserting

the jack, and turn it up to your desired listening level - these measures will not

only prevent your ears from being damaged but also the headphone’s drivers.

Also, note that these are high quality circuits and have been designed for

professional headphones, so care must be taken when using lower standard,

consumer quality headphones, such as earbuds or ipod phones etc, as damage

could occur.

POWER LED

A lit 2mm LED indicates that the unit is switched on. To turn the MC1.1 on see the

mains input section .