Operating instructions

Eclipse by Draper Page 3 of 4
Eclipse/H Assembly
Arrange all parts on the floor to ascertain that all parts are present (see
figure below). Eclipse will be assembled on the floor, face down, then lifted
into place around the screen and attached to the wall. You should have:
Two headboxes1 with motorized roller (goes on top) and 1
empty (goes on bottom)
Two side channels
Two side covers
One control switch
Determine how the motors power cord is to be routed once the unit is
mounted, and where the switch will be located. Make necessary
arrangements.
Determine whether you want the feet of the side covers to mount inward or
outward.
If they are to mount inward, they will need to be located on the wall
with respect to the screen, and attached to the wall using
appropriate hardware.
If they are to mount outward, they will need to be located on the
wall and holes drilled, but do not attach yet. Instead, attach them to
the side channels using pre-drilled holes.
Each headbox has a plastic channel locator attached to each end. Slide
the channels into their respective positions on these plastic channel
locators. The pieces are color-coded to help with this step.
Cover Front/Top
Channel locator
Cover F
ron
t/T
op
Fabric Guide
Retainer
Clip
If the side covers have been attached to the side channels, you can now
also attach them to the headboxes, using the pre-drilled holes. This will
hold the entire assembly together.
If the side covers have already been mounted to the wall, it is wise to add
a screw through the side channels into the 4 plastic channel locators.
The assembly is now ready to lift into place. Keep in mind the routing of
the power cord as this step is performed.
With inward facing feet, and the side covers already mounted to the
wall in step 3, lift the assembly up into place between the side covers
and attach to the side covers through the pre-drilled holes.
With outward facing feet, lift the assembly up and place over the
holes drilled in step 3. Attach to the wall using appropriate hardware.
Finish the necessary electrical connections (see Electrical Connections,
page 1, and wiring diagram on back page) and test the units operation.
Mounting the Eclipse
The assembly is now ready to lift into place. Keep in mind the routing of
the motors power cord as this step is performed. With the side covers
already mounted to the wall, lift the assembly into place and attach to the
side covers through the pre-drilled holes.
Finish the necessary electrical connections and test the units operation.