Operating instructions

Eclipse by Draper Page 2 of 4
Motor power cord
Top head box
contains motorized roller
Pan head screws
Flat head screws
Side cover
Channel locator: at each
end of both head boxes
Bottom head box
contains spring roller
Side channels
Side cover
Nylon tape
Eclipse/V Assembly
➀ The Eclipse comes partially assembled and must be partially
disassembled before it can be mounted to the wall. Once the screen is
installed, place the Eclipse on the floor in front of the screen so it can
eventually be lifted into place on the wall, encompassing the screen. Refer
to the drawing below, and make sure you can find these components:
One head box containing the motorized roller (goes on top);
One head box containing the spring roller (goes on bottom).
Two side channels.
Two side covers.
Control (s).
➁ Lightly mark the wall on either side of the screen where the Eclipse side
covers will be mounted. NOTE: This takes two people. Temporarily
position the Eclipse over the screen where it will eventually be placed.
Refer to the drawing below, and block it up to attain the desired position.
Using the side covers as a guide, mark the wall.
➂ Remove both side covers from the Eclipse, and mount them to the wall
according to the marks just made. Remove the pan head screws attaching
the side covers to the side channels and the head boxes.
The mounting feet of the side covers need to be located on the wall,
holes drilled, and securely attached to the wall using appropriate
hardware.
➃ Each head box has a plastic channel locator attached to each end, which
engages the side channel. Notice that the four channel locators are not
totally slid into the side channels, but are blocked by a flat head screw.
Slide the head box away from the side channel enough to back out the
flat head screw, then reinsert the channel locator into the side channel.
Re-install the four flat head screws through pre-drilled holes in the Side
channels.
Note—The black nylon tape is attached to the slat bar on the spring roller
fabric. The tapes will offer some resistance during this step, since you are
pulling against the spring roller, but this is normal.
Mounting the Eclipse
➀ The assembly is now ready to lift into place. Keep in mind the routing of
the motor’s power cord as this step is performed. With the side covers
already mounted to the wall, lift the assembly into place and attach to the
side covers using the predrilled holes.
➁ Finish the necessary electrical connections and test the unit’s operation.