Owner`s manual

- 3 -

CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V)

To eliminate the possibility of an electric shock your machine has been fitted with a BS

approved, non rewireable moulded plug and cable which incorporates a fuse, the value

of which is indicated on the pin face of the plug. Should the fuse need to be replaced an

approved BS1362 fuse must be used of the same rating, marked thus .

The fuse cover is detachable, never use the plug with the cover omitted. If a replacement

fuse cover is required, ensure it is of the same colour as that visible on the pin face of the

plug (i.e. red). Fuse covers are available from your Draper Tools stockist.

If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable

should now be suitably prepared and the correct type of plug fitted. See below.

*WARNING:

A plug with bare flexible wires exposed is hazardous if engaged in a live power socket

outlet.

WARNING:THIS APPLIANCE MUST BE EARTHED.

The mains lead is coloured Green and Yellow - Earth, Blue – Neutral & Brown – Live.

As these colours may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured green and yellow must be connected to the terminal in your

plug marked with the letter ‘E’ or by the earth symbol or coloured green or green

and yellow. The wire which is coloured blue must be connected to the terminal which is

marked with the letter ‘N’ or coloured black or blue. The wire which is coloured brown

must be connected to the terminal which is marked with the letter ‘L’ or coloured red or

brown.

EXTENSION LEAD CHART:

Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of tool.

POWER SUPPLY

7.5M

15M

22.5M

30M

40M

0.75

1.25

1.0

1.25

1.5

1.25

1.5

2.5

Wire Size mm2

Extension cable length

Ampere rating

(on Name plate)

3 6 10 13