Owner`s manual

OPERATION AND USE
1. The table ✰✌ Fig. 17 can be raised or
lowered on the drill press column by
loosening the table clamp handle ✱✌ and
turning the table raising and lowering handle
✲✌. After the table is at the desired height,
tighten handle ✱✌.
2. The table can be rotated 360º on the table
bracket by loosening lock handle ✳✌Fig. 18.
3. The table can be tilted right or left by
unscrewing and removing the table alignment
grub screw Fig. 18.
4. Loosen table locking bolt ✴✌(Fig.19) tilt
table to desired angle. Retighten bolt ✴✌.
When returning table to the level position
replace table alignment grub screw. This will
automatically position the table surface at 90º
to the spindle.
5. A tilt scale ✵✌ Fig. 20 is provided on the
table bracket casting to indicate the degree
of tilt. A cursor line ✶✌ is also provided on
the table to line up with the scale.
- 13 -
Fig.17.
Fig.18.
Fig.19.
Fig.20.
✰✌
✱✌
✲✌
✴✌
✳✌
✶✌
✵✌