Owner`s manual

- 10 -
TROUBLESHOOTING
Motor does not
start.
1. Fuse.
2. Brushes warn.
3. Other.
Trouble
Probable Cause
Remedy
1. 13 amp time delay fuse or
circuit breaker.
2. See page 8.
3. Authorized service agent.
General
Trouble
Powerhead wobbles
Power head will
not rise fully.
Disc binds jams
Probable cause
1. Improper operation
2.Warped disc.
1. Disc not round.
2. Disc damaged.
3. Disc loose.
4. Other
Remedy
1. See basic saw operation
2. Replace disc
1. Replace disc
2. Replace disc
3. Tighten wheel flang
securing bolt.
4. Authorised service agent.
Tool vibrates
or shakes
WARNING: FOR YOUR OWN SAFETY ALWAYS TURN THE MAIN SWITCH ON
THE MACHINE ‘OFF’ AND REMOVE THE PLUG FROM THE POWER
SUPPLY BEFORE CARRING OUT ANY MAINTENANCE OR
TROUBLESHOOTING.
1. Part failure
2. Pivot spring not
replaced
properly after service.
Motor
1. Loose pivot points
1. Check/replace worn parts
1.Authorised service agent
2.Authorised service agent