Owner`s manual

- 10 -
WARNING: FOR YOUR OWN SAFETY ALWAYS TURN THE MAIN SWITCH ON THE
MACHINE “OFF” AND REMOVE THE PLUG FROM THE POWER SUPPLY
BEFORE CARRYING OUT ANY MAINTENANCE OR TROUBLESHOOTING.
MOTOR
Trouble Probable Cause Remedy
Motor does not start. 1. Fuse. 1. 13 amp time delay fuse or circuit
breaker.
2. Brushes worn. 2. See “Maintenance”.
3. Other. Authorized service agent.
Brush sparking when 1. Normal - automatic brake
released. working properly.
GENERAL
Trouble Probable Cause Remedy
Angle of cut not accurate. 1. Misalignment. 1. Check for worn pivot.
Powerhead wobbles. 1. Loose pivot points. 1. Check/replace worn parts.
Power head will not rise 1. Part failure. 1. Authorized service agent.
fully. 2. Pivot spring not replaced 2. Authorized service agent.
properly after service.
Disc binds, jams 1. Improper operation. 1. See basic saw operation.
2. Warped disc. 2. Replace disc.
Tool vibrates or shakes. 1. Disc not round. 1. Replace disc.
2. Disc damaged. 2. Replace disc.
3. Disc loose. 3. Tighten wheel flange securing bolt.
4. Other. 4. Authorized service agent.
TROUBLESHOOTING