MF 9795 - Home

DynaFlex Header
PAGE 7
Smartrac
™
keeps your headers
inline. Effortlessly.
Keeping headers operating at the correct position
when harvesting over rolling terrain or terraces is
always a challenge. But Massey Ferguson Smartrac
takes the guesswork out of getting it right. And
keeping it right. Simple switches in the operator’s
hydro handle control header raise, lower, and float
functions on the header. Eight degrees of lateral tilt
is usually optimal on the most rolling terrain. When
you’d rather assume manual control, just flip a switch
and it’s all yours.
Smartrac Header Sensor Rods
Smartrac header sensor rods follow ground contours
signaling the hydraulic system to correct the lateral
position of the header accordingly. Automatic
operation improves crop harvesting performance and
reduces operator fatigue. Header automatically levels
when raised to full transport position.
Bat Flip Over Kit
The optional Bat Flip Over Kit
changes the bat pattern to allow a
better work in small or flat crops.
Flexible Cutterbar
The fully flexible cutterbar is
controled hydraulically from the
cab and allows for up to 8 in.
(203 mm) of vertical travel.
No Adapter Needed
The MF9250 DynaFlex hooks
directly to the combine feederhouse
without any adapter in between.
Two hydraulic cylinder allow to tilt
the header 12 degrees to adjust the
header for the best cutting angle.
Dual Sickle Drive
A dual mechanical SCH epiciclical
sickle drive is balanced for a
reduced vibration, higher sickle
speed (1,200 strokes/min) and up to
400% increase in cutting torque.
8 Degrees of Tilt
One large double-acting hydraulic cylinder powers the Smartrac lateral tilt frame which pivots a total of 8
degrees on a large steel pin located at the bottom center of the feed house.