Quick-Start Guide

StageScreen by Draper page 2 of 2

www

.draperinc.com

(765) 987-799

Notes for Wall Mounting

If wall mounting, do not use any stiffener bars. Product does not ship

with any mounting hardware. Anticipate the weight of this product with

proper support into studs. Do not rely on drywall only to hold screen! It

is the installer's responsibility to choose hardware appropriate for the

weight of the screen and the mounting surface

Wall Mounting StageScreen

This bracket kit is to be used when wall-mounting a StageScreen only. The

number of wall-mount bracket kits required for your screen (if wall-mounting

a previously ﬂown screen) corresponds with both the number and location of

“ﬂy points” shown on the frame map. Contact Draper if you have questions as

to the number or location of wall-mount brackets for your screen. Wall mount

bracket is ordered separately under part number 383827.

PLEASE NOTE: Prior to mounting brackets to wall, locate & measure loca-

tions along the top horizontal of your StageScreen to allow the brackets to

be placed away from frame section unions & vertical rungs. The ladder-truss

design of your StageScreen provides many mounting location possibilities for

wall brackets. Ideally the brackets will be at the mid-point of a frame section &

centered between vertical rungs.

1 Attach bracket to wall (illustration shows three ¼" x 3" lag bolts [A]. It is the

installer's responsibility to choose hardware appropriate for the weight of

the screen and the mounting surface). EACH OF THE THREE MOUNTING

HOLES SHOULD BE UTILIZED WITH APPROPRIATE FASTENERS!

Please Note: Always mount wall brackets to a wall stud or a suitable

structure using appropriate mounting hardware.

2 Position top horizontal member of the StageScreen frame over the wall-

mount brackets as shown.

Please Note: Steps #3-#5 lock the StageScreen frame to the mounting

brackets to prevent the screen from being dislodged from the brackets.

3 Thread the top two #10-24 x

" fasteners (B) into the tapped holes on the

wall bracket until they contact the wall.

4 Drill hole through one wall of StageScreen frame tube with #20 (.1610")

drill bit; using wall bracket as a drill guide (C).

5 Thread the self-tapping #10-24 x

" fastener (C) through the tapped hole

in the bracket & through the hole in the StageScreen tube.

Please Note: if desired, the wall mount bracket can also be placed at the

BOTTOM of the screen to:

a. Secure the screen to the wall on the bottom as well as the top.

b. Adjust the bottom horizontal member (if needed) to correct deﬂection.