Quick-Start Guide

Profile by Draper
Page 3 of 4
FROM CENTER TO CORNER
FROM CENTER TO CORNER
VIEWING
SURFACE
UNTIL ALL
WRINKLES HAVE
BEEN REMOVED
GENTLY PINCH
FABRIC AT
CORNER
Smoothing Viewing Service
Turn over entire screen and inspect the viewing surface for wrinkles.
If wrinkles are present, massage the fabric from the middle of the frame
to the corners. Using your thumb and forefinger, gently pinch fabric at the
corners until all wrinkles have been removed (see Fig. 15).
Attaching Trim Frame
Once viewing surface is completely flat, carefully trim the excess fabric
from the corners, taking care not to wrinkle or damage the fabric.
Carefully place trim frame extrusion over Profile frame, taking care not
to damage viewing surface (see Fig. 17). Gently tap into place using a
rubber mallet.
Repeat on the 3 remaining sides. Make sure mitered edges of extrusions
line up properly in all 4 corners.
The Profile Permanently Tensioned Projection Screen by Draper
is now completely assembled.
Figure
[phone]
www
.draperinc.com
Caution: When lifting assembled
screen, do not lift at only one corner;
lift at both corners. Lifting by one corner
could result in damage to the screen
frame, especially on large screens.
Figure
Press on
Section of
Trim Frame
VIEWING
SURFACE
S
U
R
F
A
C
E
TAP
Rubber Mallet
Profile Frame —Side Detail*
*Viewing surface is approx.
1
5
/8" (41mm) from wall.
Minimum distance between
top edge of Wall Mount Bracket
and ceiling is 5" (127mm).
Top edge of
Wall Mount
Bracket
4
7
/16"
(113mm)
1
23
/32"
(44mm)
The Profile has a precision-cut mitered-corner trim frame.
Please Note: DO NOT LIFT PRODUCT BY TRIM FRAME.
The entire assembled screen should be lifted from the bottom,
and the sides supported during mounting and maintenance.
Profile Frame (Exploded View)