Programming instructions

Fascia for Battery and 24 Volt Dual Roller FlexShade by Draper
Page 3 of 3
www
.draperinc.com
(765) 987-799
9
Adjust Limits in User Mode
If your initial limits have changed or you want to fine tune a motor, you do
not need to reset the motor and re-program it. You can just change the limits
with these steps.
1 Move the motor to the limit (upper or lower) that you want to change.
2 Press and hold the UP and DOWN buttons until the motor jogs.
3 Move the motor to its new limit location.
4 Press and hold the STOP button until the shade jogs.
Field Adjustments
Each Draper Solar Control Shade is tested to ensure proper operation.
Even with this testing, some field adjustments may be needed for telescoping.
If the shade is telescoping, place a piece of high quality gaffer tape about 1"
wide on the exposed roller (where the fabric will cover it) on the side that you
want the fabric drawn toward. For example: if the fabric is tracking to the left,
place the tape on the right side.
Cleaning and Maintenance
Window covering products manufactured by Draper, when properly in-
stalled, should require no operational maintenance or lubrication.
Most of Draper’s standard fabrics may be cleaned at the window by
vacuuming with a soft brush attachment. They may also be cleaned by using a
sponge or soft cloth and mild solution of warm soapy water. A dishwashing liq
-
uid, such as Ivory liquid, is recommended. A clean dry cloth is recommended
for the metal finish. Exceptions are Flocké, Roc-Rol, Vizela, Avila Twilight,
Edessa Twilight and SW7000 fabrics, which must be cleaned with a dry
art sponge.
Setting an Intermediate Stop
Once the shade is in USER mode from the initial programming at top.
1 Move the motor to the mid-point location that you want the stop located.
2 Press and hold the STOP button until the motor jogs.
3 Now, if you hit the STOP button when the motor is standing still, it will move
to that intermediate location.
4 If you want to delete the stop, then go to the intermediate stop and press
and hold the STOP button until the motor jogs.
Add/Delete a Channel/Transmitter
To add a channel/transmitter:
1 Select the channel/transmitter that is currently operating the motor, then
press the programming button until the motor jogs.
2 Select the new channel/transmitter that you want to add to the motor, then
press the programming button until the motor jogs.
3 The motor should now work on both the old and new channel/transmitter.
To delete a channel/transmitter:
1 Select the channel/transmitter that is currently operating the motor and
you want to keep, then press and hold the programming button until the
motor jogs.
2 Select the channel/transmitter that you want to remove, then press and
hold the programming button until the motor jogs.
3 The motor should now only work on the channel/transmitter on step 1.
Please Note: For instructions with Programmable Timer,
please consult instructions provided with the timer.
Channel selector
button on
Multi-Channel
Transmitter
4
3
/ 4 "
7"
Overall Width
Slat Bar
Fabric Width =
Overall Width - 1
5
/8"
1
11
/16"
When measuring
shade height,
remember to
include endcaps
and fascia.
3"
11
/16"
11
/16"
3"
3
/32"
Dimensions